Installing UC**BN
|
Installing UniMac UC**BN Chemical Corner –
Chemical Signals – 220v ac (most machines)– Located in panel on back of machine. On these you should really look at the Installation Manual for electrical information. There are many different power configurations for these models. Refer to pgs 70-74 in the Installation Manual.
To view the Installation Manual online, use the following link: http://www.unimac.com/tech_pdf/F232135en.pdf Pump Power - The UC--BN models are wired from the factory to supply power for chemical pumps. Refer to the installation manual pg. 70-74, for more information. There are several different configurations. The manual is well illustrated.
Here is a link to the Programming Manual (A & B control): http://www.unimac.com/tech_pdf/4-07-137.pdf
Programming (B-Control) - These controls are programmable. I don’t have very much experience with these models, and probably won’t be able to help much. To enter programming mode: Open machine lid. Locate Program/Run switch on the computer board. Flip switch to the left (as seen from the front). Display should read “0000” or temperature (depending on version of control). At this point you are going to have to hit the Programming manual. I can telling you that these are very programmable. Even the coin machines.
Programming (A-Control) - These controls are programmable, but the options are very limited. I don’t have very much experience with these models either. To enter programming mode: Open machine lid. Locate Program/Run switch on the computer board. Flip switch to the left (as seen from the front). Display should read “tSFL” or temperature (depending on version of control). At this point you are going to have to hit the Programming manual. Most of the programming the is available, is for vending, and extending bath times. |
